Newtown residents to get grinder pump system
For Newtown’s water and sewer expansion project, McMinnville officials have given their OK for property owners to use the grinder pump system, while the city handles maintenance and repair.
In September, officials were asked to consider the switch from gravity sewer lines to grinder pumps for areas like Newtown because the gravity system would be very difficult to install given the area.
The old system of using gravity requires a larger sewer pipe to be on a downhill slope from where it begins until it reaches a tap into the city’s central sewer system. Making sure the line is accurately placed requires a lot of excavation and in some areas that is extremely difficult.
However, the grinder pump system is perfect for areas that are difficult for the gravity system. It can be placed in hilly, rocky, flat or wet areas and requires a smaller pipe just below the surface. The sewer from this system can travel through elevation changes of over 138 feet until it taps into one of the city’s current sewer lines.
Unlike the gravity sewer system, which is paid for by the city except for a connection fee, property owners will have the burden of the cost of a grinder pump system. An estimated $4,000 will be needed for the system, installation and connection. About the same cost as a septic tank, say officials.
Where the $4,000 goes:
‘ System pump and the basin it fits in will be $1,950
‘ Installation will be $1,500
‘ Connection fee will be $550, normally $750.
Because the system uses electricity, an electrician will be needed to place an electrical box outside so repairmen can disconnect the electricity and do work to the pump. This adds a little more to the $4,000 estimate.
‘I’ve called about every electrician in town and it is hard to get a definite price, because there are so many variables like what size fuse box you have,’ said Water and Wastewater director Carl Davis. ‘Mostly, it is about $250 to $300. Commercial will probably be a bit more.’
The biggest question put forth by officials in September was who should handle the maintenance and repair ‘ landowners or the city of McMinnville?
If the landowners are responsible, they would have to pay for any repairs or replacement of the pump. If the Water and Wastewater Department takes responsibility, an employee would have to drive out, remove the bad pump from the basin, and put in one that works.
According to Davis, his department will handle maintenance and repair of the pump. However, there will be an $8 charge placed on the monthly water bill. The maintenance charge does not include any problems other than those of the pump.
‘If the water is getting to the basin, it is the city’s problem,’ said Mayor Royce Davenport. ‘If the water isn’t getting to the basin, it is the homeowner’s problem.’
The idea was acceptable to officials who passed the agreement for installation of grinder pump-pressure sewer systems.
‘What I like about this setup is we don’t repair it there,’ said Alderman Billy Wood. ‘If there is a problem we literally go out, pull that one out, put a new one in, plug it in and then our guys are gone. They will be working on it in the dry and under lights instead of standing out there in the rain.’
